DIY Home Improvement Forum banner

Diagnosing Adams Speedflame igniter

2346 Views 3 Replies 2 Participants Last post by  beenthere
I've got an Adams speedflame that won't ignite. It's got a spark igniter but it does not spark. I tried to check voltage across the terminal where the igniter is plugged into but it only reads a few volts (most likely phantom power). Any ideas on what I can check?
1 - 1 of 4 Posts
Not familiar with that module.

If your getting 24 volts to the gas valve but not spark. if the wire isn't grounded out, its usually the module.
1 - 1 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.