I have two zones connected to one heat pump. The upstairs damper motor has loose wires. If I jiggle the two red wires on the motor it will begin to spin, but I have to climb into the attic and do this about once a day. I can't see an obvious way to remove the small housing from the motor to access where the wires seem to be loose. Any help? :huh: The photos below are of the motor with the loose wires and the label on the main damper unit:

Click for full size - Uploaded with plasq's Skitch

Click for full size - Uploaded with plasq's Skitch

Click for full size - Uploaded with plasq's Skitch

Click for full size - Uploaded with plasq's Skitch