DIY Home Improvement Forum banner
1 - 2 of 2 Posts

· Registered
2 Posts
Discussion Starter · #1 ·
I redid one of the bathrooms and am up to installing the floor tiles. T
he short version is -- I purchased a Ridgid Diamond Edge Blade to cut the tiles. I put it on my table saw, but when I turn the saw on the blade warps, and tends to chip the tiles. I know that I am not exceeding the max rpm's for the blade. So, what's the problem?
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.