DIY Home Improvement Forum banner

Cutting Hole in Double 2 x 10

3044 Views 5 Replies 4 Participants Last post by  Build
I need to cut a 6" hole through back to back 2" x 10"s. What do you guys recommend to do this with? Are those RotoZip tools any good?
1 - 1 of 6 Posts
So...... What did the installer say about the floor system resting on the flat 2x10, on blocks every 4'o.c., on a bearing beam?

Be sure the rims are supported, use a reciprocating saw, after you drill an access hole through both.

Be safe, G
1 - 1 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.