DIY Home Improvement Forum banner
1 - 1 of 1 Posts

·
Registered User
Joined
·
6,520 Posts
This is what is normally used for coming up through the floor. They're typically installed in the base of the cabinet or in the floor at the penetrations. I suppose it could be used at a wall, but there are some restrictive protection requirements if you opt for that. The bend radius would also be a big issue. I know that some other CSST manufacturers make wall bends but I'm not seeing one for the TracPipe system.

Here's their installation PDF and it has all the parts they make.
http://www.omegaflex.com/trac/technical/100963_OmegaFlex.pdf
 

Attachments

1 - 1 of 1 Posts
Top