Circuit Breaker, working in reverse

8863 Views 4 Replies 4 Participants Last post by Stubbie, Apr 6, 2009

dcwestcott

Discussion Starter · Apr 6, 2009 (Edited)

I have found a nice and small load center to replace my inside fuse box. The box, which is carried at Lowes, uses a 220 circuit breaker as the box main breaker. This means the breaker would need to work backwards, IE the constantly powered end is the breaker wire attachment point.

Does this work? is this allowable? Would it pass an inspection?

This breaker in not a built-in breaker. It is a normal 220 V 100A breaker, installed in one corner. I should have dug around in the box further, when I was there, for an explaination.

Save

1 - 1 of 5 Posts

hychesee

· #3 · Apr 6, 2009

Yes this is perfectly normal - if replacing your main 60 amp Edison base fuse box use nothing smaller than a 100 amp circuit breaker load center. Your question also worries me too - You do know that most poco's won't re-energize your house without a licensed electrician signing off on it right?

Save

1 - 1 of 5 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month