DIY Home Improvement Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
Hi.

I'm designing a house, and have placed alot of lights around, but when I go into 3D view, or even raytracing, only 8 lights are active. I can't seem to figure out how to get the others on, been thru all of the settings I can find and looked for anything that might have something to do with it, without any luck. Tried to google it, but haven't found anything related to this problem.

Anyone in here know what to do?

I've attached a picture of the house in 3D, where you can see that only 8 lights are on, even thought all the lights in the project are turned on, and set to be used in both 3D and raytrace.
 

Attachments

1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top