DIY Home Improvement Forum banner

ceiling joists selection

1612 2
What is the live load (the dead load is 20 pfs) for the 24 ft ceiling joists, spaced 16 inch. I will make a composite joist out of two 2x10 24ft joists.
1 - 2 of 2 Posts

3 Posts
Discussion Starter · #3 ·
I hate people who do not put a queston the right way. I just did the same, I am sorry.
Myself: previous experience - building a 8x12 shack, participating to building of a large garage (28x28 foot print), gambrel roof (ha, ha).
The house that I have bought, L shaped, with a garage under the same roof, but with only two walls. The "third wall" is, in fact, three 4x4 posts, supporting the roof.
All the house has 10 ft tall rooms, including the garage.
The roof above the garage has 8:12 slope.
I intend to build a bedroom on the first floor, and a second bedroom, in the attic. The size of the garage is 24x24 and there are ceiling joists, spaced 16 inch, 2x10 of 24 ft.
Because the attic space is not proper for the room, I will lower the joists by two feet. There will be an inner adjacent frame, 8ft tall, that will be the load bearing. The existing 10ft frame will be a small suport for the roof rafters - the bird mouth in the rafter is set on the uppper frame plate (sill?). The real support for the rafters will be a V support between the rafter and the joist and the upper ceiling joists of the attic room.
Right now, Architectural Graphic Standards by Ramsey & Sleeper mentions, for a span of 24 ft, joists of 4x10 24ft for a 60 pfs live load. For residential a dead load of 20 pfs is for heavy snowing areas but, I survived two hurricanes right over my house and, I am sure that the house is calculated for more than 20pfs (is still upright:))
I know that it might not be a liniar relationship between the size of the joist and bending stress resistence or deflection, but doubling the joists (right as you said, nailing two 2x10 24ft as a 4x10 24 ft) will do the trick. I was looking for a confirmation, taken from some detailed tables.
Thank you for answering my post and I would be grateful for any help.
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.