DIY Home Improvement Forum banner

cargo trailer - weld steel square tubes attached to aluminum skin

993 Views 4 Replies 3 Participants Last post by  Jack_Zzz

I need to install a few access / service doors in my cargo trailer. To do so, I need to cut out some 1x1 and 1x2 steel rectangular tubes and weld them perpendicularly for additional support. The trailer skin is made of aluminum and is glued tightly to steel studs.
I am concerned that if start welding, the heat will damage the aluminum or at least its paint outside.
Any trick how to avoid that?

Please advise.


See less See more
1 - 1 of 5 Posts
Any trick how to avoid that?
Ayuh,..... Keep the outside Wet,..... Drippin' wet towels, a friend with a hose,..
Whatever it takes,....
  • Like
Reactions: 2
1 - 1 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.