DIY Home Improvement Forum banner

Can I cut down a Fernco?

4454 Views 1 Reply 2 Participants Last post by  Bob Mariani
Piece of pipe between two angled fittings is only 2" and I need to cut it to access the pipe. I want to use a Fernco in case I need to get in there again in the future but they are 4" long, recommendations? Can I cut it down as long as both screw clamps have enough to grab?
1 - 2 of 2 Posts
not really, but you can slip it up all the way onto one pipe, then line the pipes up and slip it over so it centers over both pieces. So why the need to cut it?
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top