DIY Home Improvement Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter #1
Hello everyone. I have three vision cages model # 222. I love these cages except for the one flaw of haveing a huge cup holder sort of thing for a light dome. the cage is made of impact-resistant polyethylene and I dont have the slightest idea of how I would remove this thing.

any help would be appreciated.

thank you.





 

·
Old School
Joined
·
3,634 Posts
Isn't that for a ceramic heat emitter?
 

·
Registered
Joined
·
4 Posts
Discussion Starter #3
Its for a heat lamp mostly. But I live in a hot and humid place and extra heat would be unssesary and I want to remove it for more cage space.
 

·
Old School
Joined
·
3,634 Posts
Considered a router with bit 1/4" wider than the guide bearing? Just run it around the inside rim of the hole.
 

·
Registered
Joined
·
4 Posts
Discussion Starter #5
Thats perfect!! I was going to go with wire and a hot pen but a router is just so much cleaner of a cutter! Thank you very much
 

·
Registered User
Joined
·
11,730 Posts
If the same diameter, cut the bottom with grill off and glue that back on the shortened tube...., unless you want the open hole for feeding.

Gary
 
1 - 6 of 6 Posts
Top