DIY Home Improvement Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Hello
I have a strange problem.
I have aluminum wire in my basement.
There was a bad connection by a light bulb and some wires got hot.
I cut back the wires and made new connections and all looks good.
I was hammering in a staple near the wiring box the light bulb is attached to, then, the light bulb got brighter. I turn off the light and turned it back on again and the brightness was back to normal.
I hammered again, and it got brighter.
Whats up ?

I checked again, and all connections appear tight.

223sender
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top