DIY Home Improvement Forum banner

Bathtub Installation Problem

1150 Views 3 Replies 3 Participants Last post by  jwilkey
I am trying to install a new bath tub. ( metal with enamel ) and it just doesn't want to fit in. The opening is maybe an 1/8-1/4" too small.

If I slightly bent the flange to get it in, will it be a problem? I don't think it should but I don't want to crack the enamel. ( but it is made to have nails/screws put through it, the flange that is)
1 - 2 of 4 Posts
Ok, I will just notch the studs a little. Thanks!
1 - 2 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.