DIY Home Improvement Forum banner
1 - 6 of 6 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
My diverter spout needs to be replaced because it only diverts a portion of the water resulting in low shower pressure. My problem is that I have a 1" water line and all the replacement spouts only convert to 3/4". Does anyone know where I can get a diverter spout for a 1" water line?

Thanks, Lori
 

·
Registered
Joined
·
10 Posts
I have seen 3/4 connections for tubspout but not 1". If you indeed have a 1" and it protrudes from tile 1" to 2 " than you may use a bell reducer from 1" to 3/4 or from 1" to 1/2" and a nipple to make up the rest. Your spout should have the fitting towards the nose.
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top