DIY Home Improvement Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
80 Posts
Discussion Starter · #1 ·
I'm remodeling a bathroom and doing 4' of drywall at the top with 5' of pine T&G plank chair rail below it. The floor is going to be 3/4" ceramic penny round tiles.

The ceiling and the 4' of drywall at the top are already finished.

I was planning on doing the tile next, and then doing the chair rail.

However, I'm now questioning this decision because I'm not sure exactly where the chair rail is going to come out with respect to the tile. For instance, I haven't picked out a baseboard yet, and haven't decided if I want to do shoe molding. Also, all the original trim in the bathroom (door casing, window casing) is all ripped out, waiting to be stripped.

I just have a fear of putting the floor down and then finding out there is a sliver of tile along one wall.

Thoughts?

Also, does anyone know of a baseboard that is notched to accept 3/4" T&G planks? Every one I have seen is notched 1/4" for the beadboard panels.

Thanks all.
 

·
Registered
Joined
·
3,118 Posts
Walls then floors. Drywall should be off the subfloor, so tile can be under drywall edge, but tile should not touch framing, needs room for expansion. This could allow for baseboard without shoe or qtrround.
 

·
Registered
Joined
·
2,440 Posts
Pmoe,
for your base, use a 1/2" filler strip behind so the base you have seen to accept 1/4" will now accept the 3/4" pine, follow what I am saying?
Mike Hawkins:)
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top