DIY Home Improvement Forum banner
1 - 2 of 2 Posts

· Registered
Joined
·
4 Posts
Discussion Starter · #1 ·
My lights in the bathroom are on a 15A (14 gauge) circuit.

I only have 1 receptacle (GFCI) in this small bathroom that is 20A (12 gauge). I currently have this circuit wired to start at the bathroom GFCI receptacle and then it goes to the wet bar 20A receptacles (2 of them).

Is this allowed to have the bathroom and other two receptacles on the same circuit? I live in Kansas and couldn't find anything in the 2017 NEC that specifically called it out.

If it's not i'll just add another 20A breaker and run wire to the wet-bar receptacles, but was hoping I didn't need to.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top