DIY Home Improvement Forum banner
1 - 3 of 3 Posts

· Registered
1 Posts
Discussion Starter · #1 ·
Can post a picture later if it is hard to understand, but I'm sure everyone will get this problem.

Just bought a new house with a partially finished basement. It has a fixed ceili with 3 lights. One of the lights turns on and off by a switch at the basement entrance (top of stairs). The other two lights are old pull string.

I want to put some LED recessed lights in, but I want them all to be attached to the light switch. So how can I connect all of them if the ceiling is already fixed?

Trying to figure it out, but guessing I will have to tear down a lot of the ceiling to run the wiring and install the new lights
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.