DIY Home Improvement Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
1,104 Posts
got a picture? first to make sure its working , run water into the sump and see if it turns on, I personally would open the sump and see what kind of pump is in there, and go from that point..
 

·
Registered
Joined
·
1,104 Posts
ok, take a hammer and tap the top of the black pipe back and forth,and if its not glued into the fitting at the floor it should come out, then get a toilet flange for 4 inch pipe to fit down by the floor, you will have to tile the floor level with the bottom of the toilet flange..frame out the walls for proper rough out on the plumbing pipes...if it is glued and doesnt come out just cut the black pipe level with the top of the fitting sticking out of the ground..
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top