DIY Home Improvement Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
21 Posts
Discussion Starter · #1 ·
I'm using 1x4 poplar stained to match the cabinets for a backsplash on the counter top. My run is about 12 foot and my board is 10 foot when I make my splice with the 2 foot piece do I go with a standard 45 degree cut or use another angle? Would I be better off instead of using 10 and 2 to complete the run to use 8 and 4 or 6 and 6 pieced together?
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top