DIY Home Improvement Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter #1
I replaced my ASKO 1355 dishwasher combination dispenser with a new dispenser because it was malfunctioning.

The new dispenser came with different connections. This URL will show you the different connections (http://www.flickr.com/photos/[email protected]/) How do I get the connections to match correctly?

I labeled the connectors before pulleing them from the old dispenser. There front connector had only one wire. The back connector had two wires, but only one of them was attached to the connector.

How do I handle 3 wires and two sets of 2 (total of four) connectors?

Thanks in advance.
 
1 - 1 of 1 Posts
Top