DIY Home Improvement Forum banner
1 - 1 of 3 Posts

· Registered
1 Posts
Discussion Starter · #1 ·
I need to anchor furring strips into very old spalling brick and masonry (circa 1870) so I can place board and batten and insulation over it. I am concerned that Tapcons in the old masonry won't hold and also that the brick veneer itself is not well attached to the sheathing/studs underneath. Should I take the old brick wall down?
1 - 1 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.