DIY Home Improvement Forum banner

Adaptor plate for outlets

366 Views 3 Replies 3 Participants Last post by  Syncman
The outlet and switch boxes in my basement were installed with 1/2" drywall in mind. However, I used 1/4" pegboard. The switches and outlets are rock solid, but there is an irritating 1/4" gap between all the plates and pegboard. Is there a product to fill the gap? Obviously box and outlet extenders are not the answer. Must be some sort of thicker plate, or dummy plate.
1 - 1 of 4 Posts
Or make your own out of 1/4" MDF
1 - 1 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.