DIY Home Improvement Forum banner
1 - 2 of 2 Posts

· Registered
23 Posts
Discussion Starter · #1 ·
Hi Guys,

I'm running a new 240v 50 amp circuit. Going through an existing conduit (RMC maybe) that's a little bit more than 1" on the outside, so I'm assuming is 1". So 6 gauge stranded THHN. Ground 10 gauge. It's going to a jbox, and then continue on with NMB. I'll be using splitbolts 6-8 for the splice.

My question is:

The NMB will have a solid 10g ground. Should I go with solid THHN, or make my 10 foot pull through one LB easier and go stranded?

1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.