DIY Home Improvement Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
222 Posts
Discussion Starter · #1 ·
I could really use a 1" open-end ratcheting wrench (like Alden, Ratcha, et al) but cannot find them that large. (Trying to install a 1/2" copper union in a tight place with not much wrench-maneuvering room.) If you know of a source for this size, I'd be grateful for the tip.
 

·
Registered
Joined
·
222 Posts
Discussion Starter · #3 ·
Have you considered a crow's foot? Maybe not be quite as ideal, but you should be able to pick one up at any big box, hardware, or auto parts store.
Thanks for the suggestion. I found online a ratcheting adjustable wrench made by Stanley/Bostitch that might work--will depend on its minimum angle. I will keep the crow's-foot in mind.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top