DIY Home Improvement Forum banner
wood stove
1-11 of 11 Results
  1. HVAC
    Hello! I have a 1980`s~ furnace, the wall panel control looks older. I can actually see the mercury inside one of the components! I am going to do a taste test on it later tonight to see if its real mercury 🤣 (its poisonous this is a joke) Anyway, I recently setup a wood stove, and I was...
  2. Featured Topics
    There’s nothing that hits the spot more than a warm crackling fire on a cool autumn’s day with family and friends. If you’re someone who loves to frequently sit by the flames of a wood and pellet stove, then you’re also probably familiar with how much it can cost. Fireplaces on the lower...
  3. HVAC
    I replaced the gasket rope on my Englander 17-vl with Rutland 5/8" gasket rope. There are still small gaps around the door. It isnt as dense as the original. This allowed for smoke to escape into the house a few times during the winter when there wasnt enough of a draft. Am I able to glue an...
  4. Metal Fabrication
    Hi there! I have a problem restoring an antique French cast iron wood stove. As I was derusting it, one of the feet broke loose. It's the part that was holding it to the body that broke. I guess it's a bold but I am not sure. The reason I am not sure is specifically because I am having a...
  5. Building & Construction
    Wasn't sure where to post this. We just bought our first home in WA out on the Olympic Peninsula and it had, apparently at one time, a wood stove. The piping was all gone, except for what was at the ceiling (15' vaulted). We purchased a brand new wood cook stove (wood burning upper, food cooking...
  6. HVAC
    I replaced the gasket rope on my Englander 17-vl for the first time this summer with Imperial 5/8" dia but it does not create a tight seal. I also noticed the rope isnt as rigid as the original Englander rope but's it's the 5/8" required dia. It's summer so I haven't lit the wood stove to cure...
  7. Building & Construction
    Hi everyone I am new to this chat room so this question may be in the wrong category, but i'm not sure. I recently just purchased a house with a pole barn. I am planing on putting a wood burning stove out in the barn. i am just going to use the stove maybe 3-4 a week in the winter if that. I was...
  8. Building & Construction
    I posted this in the HVAC forum, but maybe it should have gone here. :( Anyway ... Hi all! I just bought a wood stove and will need a Type II hearth pad/base for it. (Type II because it's a big-a** stove that'll heat the whole house.) I could buy a pre-fab one, but I'm already over budget...
  9. Flooring
    Hi all, I just bought a wood stove and will need a Type II hearth pad/base for it. (Type II because it's a big-a** stove that'll heat the whole house.) I could buy a pre-fab one, but I'm already over budget and would rather not spend an addtional 6 or 7 hundred. So here's my question: Can...
  10. Project Showcase
    So, this is my first post to DIY forums. I'm looking for information on my Home Clarion wood cook stove, specifically, what kind of paint they were painted with, and how to replace/repair the paint. I say replace because the wife is really wanting a red and black one and the factory paint is...
  11. Roofing/Siding
    I have a garage with a triple wall threw the roof ,and it leaks.Is the rain flashing supposed to be caulked around the pipe?
1-11 of 11 Results
Top