DIY Home Improvement Forum banner
Cancel

Search Results for ‘warping’

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-3 of 3 Results

Search Tags

attic basement bathroom bathtub boiler breaker brick cabinets carpentry carrier ceiling ceiling fan chimney compressor concrete conduit construction deck dishwasher diy door drain drainage drywall duct electric electrical exterior fan fence fireplace flashing floor flooring foundation framing furnace garage generator gfci ground grout hardwood heat pump heater heating hvac insulation joist joists kitchen laminate leak led light lighting masonry mold mortar outlet paint painting patio pipe plaster plumbing porch primer remodel repair roof roofing shed shower siding sink slab stain stairs subfloor subpanel sump pump switch thermostat tile toilet trim tub vapor barrier vent ventilation vinyl wall water water heater window windows wire wiring wood
  1. Plumbing
    Before I call a plumber, I'd like to get the DIY community's thoughts on why my bathtub started to warp a few months ago, after 14 years of being completely fine. After the warping, I stopped using the tub, but prior to that, I only used the tub once a month or so. As you can see in the...
    bathtub warping
  2. Carpentry
    I'm making a new console table for my entryway, and as I've done with past furniture projects, I am using cheap framing lumber. My plan was for the top of this table to be a 3' piece of 2x12, and instead of my usual staining, I decided to try Shou Sugi Ban, the Japanese technique for burning...
    furniture shou sugi ban warping woodworking
  3. Painting
    Hello, I just purchased and had installed closet doors. They have primer on the front and back, but not on the edges. The installer warned me about warping and getting them painted ASAP. I am getting two separate suggestions from painters. One wants to remove the doors, take them to his shop...
    interior doors painting warping
1-3 of 3 Results
Top