DIY Home Improvement Forum banner
Cancel

Search Results for ‘valley flashing’

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-3 of 3 Results

Search Tags

attic basement bathroom bathtub boiler breaker brick cabinets carpentry carrier ceiling ceiling fan chimney compressor concrete conduit construction deck dishwasher diy door drain drainage drywall duct electric electrical exterior fan fence fireplace flashing floor flooring foundation framing furnace garage generator gfci ground grout hardwood heat pump heater heating hvac insulation joist joists kitchen laminate leak led light lighting masonry mold mortar outlet paint painting patio pipe plaster plumbing porch primer remodel repair roof roofing shed shower siding sink slab stain stairs subfloor subpanel sump pump switch thermostat tile toilet trim tub vapor barrier vent ventilation vinyl wall water water heater window windows wire wiring wood
  1. Roofing/Siding
    I am planning to build a curved screened porch roof with slope that varies from almost flat to 1:1. To make sure that the low slope areas don't leak, I am planning to use EPDM membrane bonded to the 3/8" plywood supported by rafters at 15". Do you see any problem installing the EPMD with...
    curved roof epdm roofing valley flashing
  2. Roofing/Siding
    Hi, Without getting into a debate as to "Why would I"..Are there any professional roofers that can tell me:When flashing a valley using Ice & water membrane AND aluminum flashing..... What goes on FIRST?.....The ice & water then the flashing.....OR the flashing then the ice and water?? I've...
    valley flashing
  3. Roofing/Siding
    Hi, I'm about to shingle a roof that's been sheated with huber zip-panels. I feel that the valleys should be better protected than only the 6" wide valley tape. Is it common practice to only use the tape instead of metal valley flashing or ice and water in the valleys when using zip roofing...
    valley flashing zip panels
1-3 of 3 Results
Top