DIY Home Improvement Forum banner
uponor
1-5 of 5 Results
  1. Plumbing
    I had a fire sprinkler system designed using pex, thinking that would be the least expensive route, but am now experiencing sticker shock that the bracket assemblies (1” tee, ½” fnpt) are $30+ each, which adds up quickly with 25 heads. I am looking for a lower cost workaround that securely...
  2. Plumbing
    Hi all, I’m building a house and I’m considering installing the supply lines myself with Uponor ProPEX. My floor plans are here: https://imgur.com/a/w9gaM. Making use of Uponor's multi-port tee's, I came up with the following supply line plan here: https://i.imgur.com/AbvA8Kl.png. Should I...
  3. HVAC
    I'm actually asking on behalf of a neighbour with the problem. We all have in-floor heating with the same thermostats, about 4 in each unit. Apparently the former owner of her townhouse unit "fooled around" (my words) with her thermostats for some now unknown reason and it is now impossible to...
  4. Plumbing
    Replaced galvanized supply lines throughout home with new PEX. PEX is not run in a manifold setup but more of a trunk and branch setup. There will be on-demand recirculation pumps on the 3/4" hot water loops at the water heater (not under sink). I planned on sliding on 1/2" thick foam rubber...
  5. Plumbing
    I am fixing to plumb a new construction in South East Texas. Single story with a 50% floored attic that will be used about once a week. The home is going to be completely sealed (walls and underside of roof deck) with spray foam insulation. The attic will be lighted with fluorescent lights...
1-5 of 5 Results
Top