DIY Home Improvement Forum banner
Cancel

Search Results for ‘un-supported ends’

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-1 of 1 Results

Search Tags

attic basement bathroom bathtub boiler breaker brick cabinets carpentry carrier ceiling ceiling fan chimney compressor concrete conduit construction deck dishwasher diy door drain drainage drywall duct electric electrical exterior fan fence fireplace flashing floor flooring foundation framing furnace garage generator gfci ground grout hardwood heat pump heater heating hvac insulation joist joists kitchen laminate leak led light lighting masonry mold mortar outlet paint painting patio pipe plaster plumbing porch primer remodel repair roof roofing shed shower siding sink slab stain stairs subfloor subpanel sump pump switch thermostat tile toilet trim tub vapor barrier vent ventilation vinyl wall water water heater window windows wire wiring wood
  1. Flooring
    Problem: Hardwood flooring (t&G) laid on stringers that rest on cement slab. But some staggered ends do not line up with stringers, so the ends flex down and are not supported in these spots. I was thinking of drilling 3/8 inch hole near ends, and filling void with some material to support...
    un-supported ends
1-1 of 1 Results
Top