DIY Home Improvement Forum banner
tube
1-6 of 6 Results
  1. HVAC
    Howdy folks, so I have a leak in my system, some background: - The system (brand new split unit) had been running ok for about 3.5 years - Currently, there is NO refrigerant AT ALL on the system (R410a) - HVAC specialist added about 300 PSI of nitrogen, and during the next 20, 30 minutes...
  2. Electrical
    Hey all, I have quite the job on my hands. I had an electrician tell me I have some knob and tube present in my house due to (2 prong receptacles in baseboard, a picture I sent him (shown below), and the presence of the ceramic knobs and tubes found in the basement (but with wiring removed?))...
  3. Plumbing
    I'm building a solar water heater with solar vacuum tubes, For my 4' pool. I have nine 20" solar vacuum tubes. Which I intend to fix 3 each into 3 separate plastic tubes. This device will either percolate (like a coffee maker), or I can use a small pump, to pump water to the lower segment...
  4. Plumbing
    I got a bit of a problem... Do you know those copper tubes that stick out of the bottom of the faucet and at the end there is a thread that you connect your flexible tube to? Well one of them in our faucet has broken when I screwed the tube back on! I think it was creased by being bent...
  5. Electrical
    I am moving two light switches about 10ft. After taking apart the wall, the wiring is knob and tube. Each conductor has a cloth like insulation that makes the 12AWG wire approximately 1/8", then that insulation has a much thicker cover that makes the whole wire approximately 1/2" in diameter...
  6. Electrical
    Hi, a little background: I live in a very old house. I rent, so I pretty much have to deal with what I've got unless something is demonstrably broken. I live on the 2nd and 3rd floor of the building; another tenant lives on the 1st floor. The original wiring is Knob & Tube, but much of it has...
1-6 of 6 Results
Top