DIY Home Improvement Forum banner
tub drain
1-9 of 9 Results
  1. Plumbing
    There is plumbing roughed in for a 2nd bathroom. There is room to put a tub in, but the drain is 17" from the studs on the short wall (where the 30" tub width would go) and 15" from the studs on the long wall (where the 60" side would go). This is frustrating because aren't most tub drains about...
  2. Plumbing
    Hello, I'm fixing up my upstairs bathroom and am wondering how I should go about venting my bath tub drain. Not sure if this is required based on the present configuration (but I think so). Tub is about 5 feet away with good slope and a trap. Presently, there is a trap at the tub that drains...
  3. Plumbing
    I ahve a 60 year old cast iron tub. I am completely replacing the drain and overflow. Here is my problem...the drain itself that goes into the drain hole and the threads into the part below that is positioned just under the drain hole...The male threaded part of the drain is not long enough to...
  4. Plumbing
    After my 80 year old cast iron plumbing began to leak I started replacing the over flow and drain assembly with PVC on my first floor bathroom tub. After finally removing the cast iron plumbing I began dry fitting the new PVC parts and discovered that the drain flange and the drain shoe/waste...
  5. Plumbing
    A few years back, I bought a house where the plumbing for a first floor bathroom had been roughed-in but no fixtures were installed. The room was framed but no drywall was hung (walls still open). Oddly the room was partially tiled (nice tile, no walls). Access from beneath the first floor is...
  6. Plumbing
    Hello all, I hope you are doing well. This is my first post. I'm a brand new home-owner and I am trying to do projects myself. I have a tub drain on the 2nd floor that leaks. It does not leak when: - someone takes a shower. - I just run the tub faucet. - I put a simple stopper over the drain...
  7. Plumbing
    Hi, My issue is this, the tub downspout is right up against a joist, normally I would notch the joist but this particular joist has been notched to death previosuly (not by me). in one spot the joist is about 80% notch. I spent alot of time reinforcing and supporting hte joist so Im confident...
  8. Plumbing
    I'm trying to replace the drain in my bathtub. I have bought 3 different drains and none will screw in all the way. One hardward store employee said that some manufacturers may have different threads on their drains and that is why the drains I have purchased won't fit properly. I can take...
  9. Plumbing
    We recently had some professional plumbing work done on our 1950s ranch home. The tub is orginal. The drain is 1 1/2" and they put a 2 3/4 D drain shoe (standard) on the tub. Now there is a rust ring (apparently due to some poor tub refinishing work in the past that was previously covered up...
1-9 of 9 Results
Top