I am currently elbow deep in a DIY pottery wheel project and am about at the point to start some assembly. Or so I thought.
The Motor that I will be powering this bad-boy with was salvaged from an old treadmill. Tech Specs are as follows
R.P.M. - 3900 MAX
Volts - 115
Thank you all for reading/replying to this post, any feedback and suggestion is greatly appreciated.
-Between the crank, rear tire, then to the motor, I have calculated roughly a 40 to 1 gear ratio.
-110V at 3100rpm/29.9amps
-500 Watt Wind Grid Tie...