DIY Home Improvement Forum banner
tongue and groove
1-6 of 6 Results
  1. Roofing/Siding
    We have a house from the 60's that is built with tongue and groove vertical siding. I read that the sidings should not be caulked. Unfortunately this has been caulked by the previous owner and recaulked by the painters 4 years ago. The caulk on the South side is starting to fail with gaps...
  2. Flooring
    We purchased 7" wide engineered hardware with tongue and groove installation to put on our raised wood sub floor house in California. We would like to put a 3 in 1 vapor barrier underlayment but the manufacturer website suggests to glue and nail floors wider then 6". If we glue it, we would not...
  3. Building & Construction
    Hello everyone. I have a brick home, and the peak on the house is 8" wide tongue and groove planks. Built in 1949, i am pretty sure it is original and needs to be replaced. Is there a tongue and groove alternative? (Cement board, vinyl, etc. Haven't found anything like that at the local stores...
  4. Carpentry
    We have a beautiful high vaulted ceiling in our grand room that are natural wood tongue and groove panels. We are in the middle of a major kitchen remodel and recently took down the track lighting from the kitchen. The lighting doesn't work where it use to be in our new kitchen configuration...
  5. Carpentry
    I will be installing a tongue and groove ceiling on the patio with 1" x 6" pine. I intend to nail into the top of the tongue so the nails will not be exposed. I've never used an automatic nail gun before and intend to purchase one for this and future jobs. Which type of nail gun would be best...
  6. Roofing/Siding
    Hi. I recently purchased a home built in 1950 in Raleigh, NC. I have removed the interior walls and ceiling to expose the beautiful tongue-and-groove roof boards that cover the gable structure. The 2x6 rafters below the decking are held in place by collar ties, and the entire load is distributed...
1-6 of 6 Results
Top