DIY Home Improvement Forum banner
tongue and groove floor
1-3 of 3 Results
  1. Tiling, ceramics, marble
    The floor of my house consists of 2x8 Doug Fir Tongue and Groove w 4ft span. It is pretty stout. I want to re-tile my bathroom floor, and would like to use the Kerdi waterproofing membrane. Based on the research I have done it sems like I am going to need a lot of layers (too many?). Here...
  2. Flooring
    Ok I have a condo with a concrete subfloor. After looking around I have decided on an engineered wood floor with a tongue & groove system(not click lock). I plan on floating the floor and glueing in the grooves. The planks are 5" wide and 1/2 thick, 2.5mm wear layer. I will either get maple...
  3. Flooring
    The ceiling/flooring over our kitchen and bathroom is 2x6 t&g. Our bedroom upstairs uses the un-beveled side of the t&g as flooring. We would like to clean it up, sand, re-finish it for a rustic floor. Is there a good way to seal in between the boards? It is not perfectly installed. I can see...
1-3 of 3 Results
Top