DIY Home Improvement Forum banner
tiling bathub wall
1-2 of 3 Results
  1. Building & Construction
    Cement board went up in my bathroom and a hole was cut for the prefabricated niche. Now I have the niche (steel, 14x36") in hand and it doesn't fit. The niche flange is sitting at least 1/4" proud of cement board, though it should have been the right depth. Confused as to how this could be...
  2. Tiling, ceramics, marble
    HI I've just installed the Bathtub by my self following the recommendation on you tube : I've put it the bathtub site stuck on the wall as shown below then install cement board 1/2 Inch , then after completely finishing the bathtub installation (install the drain kit , fixing the bathtub...
1-2 of 3 Results
Top