DIY Home Improvement Forum banner
temperature control
1-6 of 7 Results
  1. HVAC
    I have a 10-year old Lifebreath 200 Max HRV. It stopped completely a few months ago, and my local repair guy and I are at our wits' end trying to make it run again. (I live in a rural area so help is hard to find.) The fan spins freely by hand and starts up fine when we hot-wire it directly...
  2. Plumbing
    I just replaced the Mixit valve in one of my showers. The problem I have now is the new valve is hard to adjust the temperature (impossible once the water is running) and turning it off it very difficult as well. I tried adjust the sleeve nut that holds it in place by loosening it which doesn't...
  3. Appliances
    Ok - this one has me stumped. My gas oven has been having issues heating up. I set the bake function to 350 degrees and the actual oven (measured via standalone oven thermometer) barely cracks 150 degrees. Initially I just purchased a new temp sensor off of amazon and replaced it. The issue did...
  4. Electrical
    I have purchased Inkbird ITC-306T temperature controller from Amazon to hook to a heater. I want to set it so that if the temperature hits 40 degree, it will turn the heater on and then shut off when the temperature reaches 50 degree. Unfortunately, I am unable to set up the device to make that...
  5. HVAC
    Hi, I am a newbee but i am hoping someone can help. I search google and everywhere else i could think of looking and you guys are my last hope. I recently purchased a CT30 Wifi thermostat and I have a bolier with radiators throughout the house. I belive i setup the wire correctly on my new...
  6. Plumbing
    I have searched all over the internet for an answer to this problem and cannot find anyone with this issue. Hopefully someone here can relate and offer a suggestion or solution. I have a State Select Power Direct Vent water heater (model# GS6 50 YRPDT 5) with electronic iginition. Here is a...
1-6 of 7 Results
Top