DIY Home Improvement Forum banner
tailpiece
1-4 of 4 Results
  1. Plumbing
    Hello. I recently installed a new vanity in my guest bath. Seemed like it was going to be so simple. Unfortunately, I've been trying to connect the drain to the wall. The p trap and piping (outside of the sink drain) is 1.5" and would connect into the wall without issues. The issue is the...
  2. Plumbing
    Hello, I'm currently trying to remove the drain plug on a bathroom sink. The only problem is that I'm not able to remove the drain body/tailpiece from the vertical ABS pipe. The p-trap is glued (no slip nuts) so it doesn't leave me a lot of room to remove the drain body/tailpiece. Is there...
  3. Plumbing
    Does the tailpiece for a kitchen sink need to be a minimum length before it enters the p-trap? Can it be as short as 3" without causing any problems? I would like to install the drain and p-trap as high as possible to open up the area underneath the kitchen sink. Thanks for taking your time...
  4. Plumbing
    I need an offset tailpiece to solve a trap fitting problem. Has anyone seen one that looks similar to the one in the picture I've posted here. My plumber roughed in the drain too close to the sink drain and also angled it *towards* the drain so I can't even reverse the J bend to get more...
1-4 of 4 Results
Top