DIY Home Improvement Forum banner
spout
1-4 of 4 Results
  1. Plumbing
    Hello. I could really use some help. I have a new tub diverter spout that I am trying to put on. The pipe is copper, not threaded. The new spout is threaded on the inside. The original tub spout was attached via a threaded plastic adapter that goes over the copper pipe. So, I am reusing...
  2. Plumbing
    I bought a new Grohe spout the other day and I'm getting ready to install it. It has a female NPT fitting on one end and it requires very precise positioning (within 1/16"?) and the male fitting needs to be behind the cbu. I haven't even installed cbu yet in this area nor chosen my tile, so I...
  3. Plumbing
    Hey all, Today I decided to replace my broken bathtub spout, the diverter broke off so couldn't use the shower. I took off the old spout and went to hardware store , they said they had never seen a spout like mine before. It's a screw on spout with a 2" threaded opening. The pipe(nipple) coming...
  4. Plumbing
    Hi, Is there any tub diverter spout on the market with slip-fit type fit to 3/4" IPS? When I took out my old spout which was the front-end thread, the metal nipple was stuck to the end of the pipe coming out from the wall and I can't remove it. So I am going to cut the pipe and use a slip-fit...
1-4 of 4 Results
Top