DIY Home Improvement Forum banner
split
1-6 of 6 Results
  1. HVAC
    OK, I must confess I am not DIY-ing it this time, but I gotta ask... I am having a mini-split heat pump/AC unit installed in my 2-car garage, a 16 SEER, 12,000 BTU Airtemp. Both estimates I got were for the same number: $3,600. I cannot for the life of me find a definitive answer about how...
  2. HVAC
    I live near Houston Texas and I just had a house built. During the construction process I asked the build to run A/C to the attached garages, they replied that won’t for various reasons. They wouldn’t even install a mini split system. However, the builder did fully insulated all the walls and...
  3. Electrical
    New on the DIY forum, but have seen lots of great useful info. I have just installed a circuit with 3 duplex receptacles (3rd one split) with switch to control the bottom of the 3rd switch. I am using a simple circuit tester that plugs into each receptacle - it is a clear tester with orange...
  4. HVAC
    I purchased an R-410A Goodman GSX130301B 2.5 Ton condenser and an Amana AVPTC36C14 3.0 Ton Air Handler with Variable Speed with a TXV from AC4Life.com. Had a licensed relative start the install. He could not finish it so I had to get a second licensed guy to do it. The first guy cut the coil...
  5. HVAC
    Looked through the manual and understand it to a point. Was hoping to get some "polishing" from you guys. http://www.smarthome.com/3038A/Residential-Control-Systems-001-00242-ZC2S-HVAC-2-Zone-Controller/p.aspx Could this be installed to independently control the temperature and CFM of the HT...
  6. Building & Construction
    We have wooden stairs in our house on the second floor which lead up to the attic. There are a couple of large cracks along the middle of the part attached to the wall, and the paint is bubbly; there's also a gap along the bottom of the part attached to the wall...
1-6 of 6 Results
Top