Search Results for ‘shower door’

When I tiled my new shower, I forgot to put extra bracing behind where the two brackets will go for holding the heavy glass shower door. Right now it's just tile with kerdi board behind it then open space until the drywall of the wall on the other side. I know that won't be strong enough. I've...

Regarding the sealing of shower door frames to the marble sill at the bottom of the frame. I have a leak at this interface between the frame and the sill. Before I re-caulked, I noticed that only the outside of this interface is caulked; i.e. there is no caulk on the shower side of the frame...

I have a shower stall with a glass pivot door which I'd like to replace. The width of the opening is 34" wall to wall. I found a shower door kit at Home Depot but it only supports up to a width of 33.5". So I was wondering if it would be a good idea to install 2" wide trim tile on top of the...

Nice looking "walk-in", "curbless" shower has an issue... the gap under the frameless shower door is: A) not consistent, varying from 9/16" on one side, 13/16" in the middle, and 11/16" on the other side (SEE PHOTO BELOW) B) larger than any sweep I can find. C) allowing water to leak out...

I am in the middle of a basement bathroom construction and have a 40" opening for a shower door. I'd like to use a slider because of space. Does anyone know if this is going to look bad? I'm thinking about ordering it online and would appreciate any advice on this one. Cheers

I've got a perfectly good set of shower doors but they were originally installed with a calking material. After a few years, the calking deteriorates and we get some mold or stains in the crevices. Many new shower door sets come with a grey vinyl seal on a roll that never seems to deteriorate...