DIY Home Improvement Forum banner
short cycle
1-5 of 5 Results
  1. HVAC
    My furnace is "short cycling" I believe. Typically the blower will turn on for about a minute and then shut off. After that I can hear the inducer motor running for a few minutes and then the blower kicks on for a normal amount of time to complete the cycle. There have been a couple of times...
  2. HVAC
    Good afternoon... Here is the back story / history... The home is 2100 sq.ft. under HVAC located in Florida near Tampa. In 2012 - I had new windows put in - insulated, Laminated and Low-E... I told my HVAC contractor, that I was upgrading my windows and to take that into consideration when...
  3. HVAC
    I have a Maytag gas furnace (sorry, not sure of model, but its newer high efficiency kind) and its started short cycling. When the thermostat commands heat, the furnace draft fan will start, then the igniter comes on, then gas starts and flame is instant, but then the gas cuts off in 1-2...
  4. HVAC
    My furnace is short cycling, where the gas supply and burners are running for about 30 seconds at start up. After the startup cycle they begin to turn on and off about every 15 seconds. While this is happening the blower motor and inducer exhaust fan do continue to run. ~ I have installed a new...
  5. HVAC
    I have a Trane 1400XL HVAC. It's a gas furnace that's installed outside the house and is controlled by a Honeywell T8602D thermostat. This last point is likely irrelevant as the behavior doesn't change when I remove the thermostat and connect the red and white wires using an alligator...
1-5 of 5 Results
Top