DIY Home Improvement Forum banner
Cancel

Search Results for ‘shims’

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-3 of 3 Results

Search Tags

attic basement bathroom bathtub boiler breaker brick cabinets carpentry carrier ceiling ceiling fan chimney compressor concrete conduit construction deck dishwasher diy door drain drainage drywall duct electric electrical exterior fan fence fireplace flashing floor flooring foundation framing furnace garage generator gfci ground grout hardwood heat pump heater heating hvac insulation joist joists kitchen laminate leak led light lighting mold mortar outlet paint painting panel patio pipe plaster plumbing porch primer remodel repair roof roofing shed shower siding sink slab stain stairs subfloor subpanel sump pump switch thermostat tile toilet trim tub vapor barrier vent ventilation vinyl wall water water heater window windows wire wiring wood
  1. Building & Construction
    Hello! New member here....My husband and I are avid DIYers, but recently opted to contract out the installation of a complete foundation for our new home. It has been a nightmare. We desperately need some direction and advice, so please if anyone is familiar with the proper way to install a pier...
    beams code foundation pier and beam shims
  2. Building & Construction
    I removed old drywall and tile in bathroom and am replacing with drywall and panelling. The door frame sticks out farther at the top than at the bottom and I would like to know how to shim it before I put in the drywall. It would have to be at least a 4' shim going from 1/2" or 3/8" to nothing...
    door casing drywall shims
  3. Windows and Doors
    Hello DIY group, I am new to this site. I have some very old wood windows (originals to my house which was built in the 1920s), many of which do not have locks. The previous owners of my house had purchsed a lot of metal locks but never installed them because they found that the sashes are not...
    old windows shims windows
1-3 of 3 Results
Top