DIY Home Improvement Forum banner

rubber roof

  1. Roofing/Siding
    Hi there, I have a slopped roof with two layers of EPDM, the second has a granule/gravely texture. I'm installing a composite deck on tapered sleepers (cut from 2 x TBD to compensate the roof slope) and I want to ensure I separate the cut side at the bottom from the membrane/rubber to avoid...
  2. Roofing/Siding
    I just had a rubber roof professionally installed on a flat roof, over an existing tar roof. It looks good over all but I have a question about the lap joints - specifically if the joint edge/lap should be 100% sealed to the layer below it. Let me explain... The joints seem to have a 4"...
  3. Roofing/Siding
    Hello, hoping some of you may be able to take a few moments to offer some advise. I recently had my roof replaced and the roofers installed an EPDM flat rubber roof over my back porch. I noticed that there were several wrinkles/bubbles and am concerned that it may cause problem. The contractor...
  4. Roofing/Siding
    Has anybody tried the Euroshield products? They're made of recycled tires. The appearance is nice enough in the brochures, but I'd like to talk with somebody who has had real-world experience. From the description, they make all kinds of sense: - tough - quiet - insulating - recycled...
  5. Roofing/Siding
    Hi, I live in a Philadelphia rowhome. I installed cheap roof vents and in the process of cutting out the little square for the vents realized my rowhome has a metal roof covered by a rubber roof. The attic area has a lot of mold, dry rotted wood, etc. Is there supposed to be a layer of...
  6. Roofing/Siding
    We own a three story house....walls are comprised of cinder block with a stucco finish on the sides and back, brick facade on the front. This past weekend we were putting a piece of furniture together in our 2nd bedroom and found that the carpet in an area in the corner of the room was soaked...
Top