DIY Home Improvement Forum banner

Search Results for ‘rough door opening’

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-3 of 3 Results

Search Tags

attic basement bathroom bathtub beam boiler breaker brick cabinets carpentry carrier ceiling ceiling fan chimney compressor concrete conduit construction deck diy door drain drainage drywall duct electric electrical exterior fan fence fireplace flashing floor flooring foundation framing furnace garage generator gfci ground grout hardwood heat pump heater heating hvac insulation joist joists kitchen laminate leak led light lighting mold mortar outlet paint painting patio pipe plaster plumbing porch primer remodel repair roof roofing shed shower siding sink slab stain stairs subfloor subpanel sump pump switch thermostat tile toilet trim tub vapor barrier vent ventilation vinyl wall walls water water heater window windows wire wiring wood
  1. Building & Construction
    We're renovating a house built in late 1960, so everything is always not as easy replacing as it is in a newer constructions. Currently we bought a pre-hung door to replace the old one. And then ran into an issue that the rough opening width is 1/2" shorter than recommended. So when we try to...
    pre hung door prehung door rough door opening
  2. Windows and Doors
    I am looking to replace the entry door to my garage. The current door is for 2x4 walls so it isn't deep enough for 2x6 walls. Also the block rough opening is 44" wide and the door is a 36" door. The gaps are filled with OSB and it just doesn't look good (see pics). I found a few doors that would...
    exterior door rough door opening
  3. Remodeling
    Hello, I am trying to rehang a turn of the 20th century raised panel door. Unfortunatly the previous owner had removed the door and removed all the jams and put in its place a 1x6. The rough door opening after removing the 1x6 is 27 1/2 inches wide and 72 inches tall. The door measures 24 x 71...
    rough door opening
1-3 of 3 Results
Top