Search Results for ‘roof angle’

Bought a house and had a part of our roof redone due to a leak. Originally covered in shingles (the pitch is too low for shingles) so a new roofer suggested we go with rolled roofing. That's what we did. Less than 6 months after installation I saw these bubble streaks (veins?) all over that...

Hi Everyone, I hd this roof extension put on over a patio but did not realize how wierd it would look at this North East corner of the exisiting roof. Any suggestions on how to fix this? It is the complex angles at the corner that is killing me!! Thanks, DAVE

I have a U-shaped house, courtyard in the middle (concrete). Roof on all three sides angled into courtyard. I want to put a roof over it. How can I do this without it getting cramped or dark? Easiest is straight off the roof, but then the height is really low. Any suggestions or links?

Hi All, I recently had a new roof installed. We thought that everything was done properly until a tree hit the roof when Hurricane Sandy came through. We had damage that the inspector saw and the insurance company agreed was because the tree hit. Then because they gave us so little to fix it we...

My building I'm constructing is 12 ft wide, shed roof. The front wall is full 10' studs(plus the 3 plates) The back wall is 8' common(92 5/8") studs. I'm not using ceiling joists. I'm having a hard time figuring the pitch and how to cut the birdsmouth for the 2x6 rafters. Please help this...

I have a Cape Code style house with a 7/12 roof pitch, so some of the ceiling in the 2nd floor bedrooms slope with the roof's pitch. I'm planning to put in a shed dormer on the back to accommodate a new bath upstairs. Does the pitch of the roof matter when planning for shed dormers? Is 7/12 too...

I’ve replaced the door and it’s working well but I need to fix another problem. I’m not sure what direction to go. I replaced the door because of rotting caused by poor water drainage. I’ve attached a few photos that should help understand this particular situation. The roof is angled...