DIY Home Improvement Forum banner
ridge vent and peak caps
1-3 of 3 Results
  1. Roofing/Siding
    Hi. I've been a Roofer/Sider for most of my life and never encountered a problem like this before. The Builder who built the house I am roofing messed up big time. Just finished the entire roof (half 12 pitch and shed dormers on the other half with that half with a 7 pitch) with asphalt...
  2. Roofing/Siding
    Hi folks I'm working on a 10'x10' shed with a 4/12 gable roof. What is the ideal sized gap in the plywood at the ridge for the ridge cap vent? My target was 3" on each side, but I forgot to figure for the fascia board so I ended with a little more than 4" on each side to the ridge. Is this...
  3. Roofing/Siding
    I recently had a GAF lifetime system installed and noted that the Timbertex Hip and Ridge shingles used to cap the ridge vent and all peaks have very rough edges from which the grit is missing (1/8 to 1/4 inch missing in some places. When I contacted the roofing contractor about this, he...
1-3 of 3 Results
Top