DIY Home Improvement Forum banner
Cancel

Search Results for ‘relief valve’

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-3 of 3 Results

Search Tags

attic basement bathroom bathtub boiler breaker brick cabinets carpentry carrier ceiling ceiling fan chimney compressor concrete conduit construction deck dishwasher diy door drain drainage drywall duct electric electrical exterior fan fence fireplace flashing floor flooring foundation framing furnace garage generator gfci ground grout hardwood heat pump heater heating hvac insulation joist joists kitchen laminate leak led light lighting masonry mold mortar outlet paint painting patio pipe plaster plumbing porch primer remodel repair roof roofing shed shower siding sink slab stain stairs subfloor subpanel sump pump switch thermostat tile toilet trim tub vapor barrier vent ventilation vinyl wall water water heater window windows wire wiring wood
  1. HVAC
    Hi there, I have a 20 year old Weil-McLain Gold CGa gas-fired water boiler that drives two heating loops in my house. We've apparently had a pinhole leak somewhere in the system forever, so the internal pressure of the system would slowly drop from 20 psi to near zero by the end of each...
    hydronic baseboard heat hydronic expansion tank relief valve
  2. HVAC
    Hello all just looking for some advice. My safety valve keeps popping on my furnace. Last year I replaced the automatic make up feed water valve due to leaking by and over pressurizing. I turned off the manual feed water valve before that and watched the furnace operation. It was working fine...
    boiler overpressure relief valve safety valve
  3. HVAC
    Hello, I have a Dunkirk XEB-6 furnace. First, the pressure was a little bit high around 25 psi. The manual said that the pressure should between 12 and 20 psi. I thought that the relief valve is not working. so i went ahead and tested it by lifting the lever and releasing some water. after...
    dunkirk furnace pressure reducing pressure relief valve
1-3 of 3 Results
Top