DIY Home Improvement Forum banner
regulator
1-9 of 9 Results
  1. Plumbing
    How may turns should it typically take to see a change in pressure when adjusting a residential pressure regulator? I turned mine 1.5 turns in either direction (while repeatedly opening and closing a spigot), but have not seen the slightest change in pressure. I'm wondering if it requires many...
  2. General DIY Discussions
    I have a Craftsman 150 PSI Compressor (Model: 919.167310). I just purchased a new Air Regulator to replace the original one that I thought had gone bad since it would drain the main tank pressure to whatever I set the Regulator pressure to. However, when I replaced the old reg with the new reg...
  3. Tools
    I have a Craftsman 150 PSI Compressor (Model: 919.167310). I just purchased a new Air Regulator to replace the original one that I thought had gone bad since it would drain the main tank pressure to whatever I set the Regulator pressure to. However, when I replaced the old reg with the new reg...
  4. Tools
    I have a Craftsman 150 PSI Compressor (Model: 919.167310). I just purchased a new Air Regulator to replace the original one that I thought had gone bad since it would drain the main tank pressure to whatever I set the Regulator pressure to. However, when I replaced the old reg with the new reg...
  5. HVAC
    Residential 2psi natural gas service. Gas comes into a manifold where the line regulator dumbs it down to 9 inches wc before going out to the furnace and hot water heater (only gas appliances). Recently noticed that when nothing is calling for gas, the post-regulator pressure creeps up over...
  6. Plumbing
    I have a couple of 120 gallon LP tanks which feed my combi boiler. I want these tanks to also feed my dual fuel generator, but my gas company won't tee off the tanks for this purpose. While having my boiler cleaned, the tech said that I can tee off the line after the LP passes through the...
  7. HVAC
    I recently did a complete overhaul of my natural gas distribution system. This is always a subject that generates discussion – should a DIYer try it or not? My conclusion is that if you are willing to do quite a bit of advance research (including reading up on code requirements), put an equal...
  8. HVAC
    Furnace pressure switch line/nipple question I recently had my inducer/exhaust fan replaced and several times since have found the new inducer fan running but the unit wouldn't fire up. On investigating I find that there are three hoses to...
  9. General DIY Discussions
    I live off grid and use solar to charge a large 24v battery bank for my electricity. I have tried using 24v automotive alternators but cannot figure out how to limit the current of the alternator. The battery bank is large so when the alternator kicks in there is a huge draw and it puts too much...
1-9 of 9 Results
Top