DIY Home Improvement Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-3 of 3 Results
  1. Plumbing
    I started with 3/4 inch pex feed to 1/2 inch pex to fixtures. I noticed the pex fitting ( elbows , Ts, etc.) have an inside diameter of 1/2 inch for the 3/4 inch fittings and 1/4 inch diameter for 1/2 fittings . Does this reduced diameter in the pex fittings reduce the flow of water ?? I...
  2. Plumbing
    I am plumbing a new house and would love to place the pex manifolds in the attic next to each water heater to save space and to make the runs as short as possible. I will have a main cold water cut off inside the master bedroom closet where the main water supply enters the house. In addition...
  3. Plumbing
    my plumber recently installed a PEX tubing run from my current copper pipe with a T fitting. It seems that there is a lot of stress on this joint because he immediatly did a 90degree turn with the tube. Will this work? (see photo)
1-3 of 3 Results