DIY Home Improvement Forum banner

oven installation

  1. Electrical
    putting in a wall oven. ran 12 gage solid wire because it called out for 20 amp. got the wall oven in hand and it has 8 gage stranded coming out of the whip. i know the oven is 220 volts and 12 gage is suppose to be for 110 volts, but i could take the white neutral wire and run another 110 volts...
  2. General DIY Discussions
    I am needing to disable the gas to my house because the last owner apparently did not add a gas shut off valve to the oven. I have never done this and would like to not explode. I attached pictures of my gas water heater (pics 2 and 3) and the gas shut off valve on my AC unit (pic 4, I think it...
  3. New Member Introductions
    Hi, I'm looking to replace my current oven with a new oven which calls for a 30amp circuit. My current oven circuit is 40amps We are planning on pulling old oven out ourselves. Doesn't seem too complicated. I am concerned about the new oven GE PT7800 needing 30A while old GE Profile called...
  4. Carpentry
    I'm installing a built-in oven in an 80" high pantry cabinet. The oven installation instructions say to allow a minimum cutout depth of 23 1/2". The cabinet depth is 23 3/4", but that includes 3/4" for the rear panel, so the interior depth is only 23". I can add a face frame if necessary, to...
Top